Search results

Thanks, I'll have to remove the top end and take a look to see what damage was done...looked like it was just around the seal on both engines...sure pumped a lot of water into the boat though..what sealant should I use for the new seals? Thanks, Glenn

Only had the boat in the water once a year for the past several years...now must not have gotten winterized properly because took it out a couple of weeks ago and there was a lot of water in engine compartment..when I pulled the plug on the boat ramp it came shooting out and was warm water...I...

Thanks LawnDart...couldn't afford the OEM Bimini....lol

Purchased from Amazon for $159....

Hi hivoltage98, I purchased the 3 Bow 6'L x 46"H x 79"-84"W with the straight pole in the back so you can put the top up with the cover on it so it is out of the way of the storage area. Then when you get to the cove you can open up the top for shade. It's tall enough that you can stand up and...

Thanks hfgreg...will check it out as both you and mikidymac have suggested...

Hi RogerS...I'd start by checking all my wiring connections at start button and at starter. Then check to see if your start button is bad.

Wow, expensive for what was done... I like to do my own repairs just for what you stated...poor work by shops and when you pick up your boat you have to check and finish what you had paid for...Hope they got the oil lines filled properly and didn't make another mess in the engine...

Thanks mikidymac, was hoping someone had found a way to do this. I'm thinking a vinyl decal applied to the vinyl of the sun deck...

Was wondering if anyone had any idea on how to replace the faded graphic Challenger 1800 that was on the Sun Deck of a 97 Challenger 1800. Anyone done this or know of where to get a graphic or what works best? Thanks in advance...

Wow...your boat really came out nice...I like the colors and the graphics look awesome. Glad you're finally enjoying your boat and who doesn't like a clean boat. Looks like you had a great evening at the lake..so serene. These boats are a lot of fun and nice we can do most of the work on them...

Wow you had that one down to the bones...nice looking boat...will be lots of fun on the water.....

Lots of nice color combinations here, with the different color of the boats, interior, graphics...etc...you can't go wrong with any combination...

Thanks, it was in nice shape when I bought it...it had set on a lift covered up the last few years..got lucky....

Hi To2d, I found those on ebay and were in Canada..they were original Sea Doo mats for my boat..they were a one of a kind and only that color combo...but worked out perfect for my boat.

I installed my Sea Doo mats in my boat...used the 3M spray adhesive...I taped off the area around the mats so I could spray without overspray and also spray the mats themselves. Adhesive worked great and so far mats are staying down after a trip to the lake. Here is what they look like...

Looks great, the grey color worked out nice, bet it will be nice on your feet and also cut down on slipping...

Hi All, want to mount my depth finder/temp gauge to rear transom. Was wondering if anyone has put a grommet (like the one used for the speedometer wiring that goes through the rear plate) into the other plate in order to run the wire for the depth finder? If so what is required to run the wire...

Hi all, was able to take my new to me 1997 Challenger 1800 out to the lake for a few hours yesterday...engines performed flawlessly. Noticed the fuel gauge is inoperative, speedometer works but jumps to 50mph rather quickly...one tach is working, the other stays at about 1500 rpm even though...

Replaced the oil tank vent valve and cleaned up all the old spillage in the engine compartment and after taking the boat out happy to say that took care of the oil leakage. Tested the old valve and it was bad as it allowed air to be blown thru it in both directions.