Search results

Likely guessed it, one rounded... Challenger 210. Anyone able to tell me if aluminum or stainless steel (211500001) - trying to decide whether want to attempt drilling / extractor and am a little more hesitant with stainless steel. Seemed soft in the manner it rounded thus thinking...

This carpet was in use 2012-2017 during which time to boat saw ~50 hours on motors. Fair-good condition, all snaps in place, no stains. Havent tried scrubbing bottom to see if cleans up (dont see it), photo to show no damage / rot. Located in Vancouver BC, can ship from Blaine. Price...

Know others here have had them play hide and seek as well, found a source. https://www.corsa-technic.com/item.php?item_id=721&category_id=117

So about to pull plugs to crank storage oil out of cylinder, coil comes out without plastic cover and part of sealing cup... Managed to remove plastic sleeve - in pieces... Hence, does plastic sleeve serve a purpose, or okay to run this week without...

May have the opportunity to store boat a lot closer to lake - where also more susceptible to theft... Your recommendations for trackers are... ? If relevant to subscription requirement, boat / use is in primarily in BC, sometimes WA. As an aside, a while back read about one that uses a phone...

Thinking of removing the carpet and replacing with BlackTip traction mat (HydroTurf apparently does not have a pattern for the 210 Challenger). For the OCD type that is likely to use a gel coat patch material (thinking spectrum) to fill the screw holes... how much is needed 2oz, 1/4 pint...

Read challenger 210 na 155s manual, searched forum, even phoned Recochem but no luck so far with coolant selection, help appreciated. Manual states ethylene-glycol for aluminium motors. Recochem states more to it than that and there should be a "specification" provided by the manufacturer...

Hi, just curious where the exit is for the exhaust flush port the Challenger 210 SE 310hp. Ran motor briefly to stall it on fogging oil (so 15 seconds if that). Some water expelled. Connected air compressor to flush port and some more water was expelled that dripped out of impeller intake /...