Search results

I have 2000 gs 717, and have water leaking around one of my head bolt, when it's on the hose. I was thinking about removing bolt and filling hole with sealant,than put bolt slightly threw hole, and let dry than push in further than tighten

I been having trouble trying to start my 01 717 with air box on, it run fine with just flame aristor, so I just wanted to see what's going on, so I put it on the hose and just put air box on, no flame aristor, and put cover on, forgot to latch down, and fired it up, it blew the cover off, it was...

I just completed a long total rebuilt on a 717 gs, going to lake Saturday for 1st run. I have some concerns about the oil injection system working correct. I have med range octane in the tank, I was thinking about adding a little 2 stroke oil to the gas, to be on safe side. Than I do not want to...

I recently bought a new ignition coil on Amazon, well that did not work out, bad coil. I wish that I new a more reliable source

I looking for a source for a RV cover other than SBT, not sure if allowed to post thread

I did not do this procedure, heating flywheel and ring gear with loctite 648 on my 2000 gs 717, no wonder having starting problems with ignition timing. What position should ring be in set inside flywheel

2000 gs 717 Which spark plug wire, 2 spark wires far right out of rear electrical box, go closest to mag side, manual diagram not quite showing see pic

I read about posters who changed there rotary valve setting from 147 to 130 to get it started when they where on the low end of the compression scale, is there any truth that this might work, on a 717 I am in a like position, and wanted to wait over the winter, to do a top end

Should I have use the inside reading or outside reading from the 360 mark, my 717 calls for 147 degrees see pic

Is this the location of fuel filter, top right pic, on a 2000 gs 717, thinking about changing location of filter for its easy to change.

Should I put some fogging oil in my my spark plug holes before starting, It's been 2 weeks since my rebuilt since my complete rebuild. I live here in Texas been 112 for 2 weeks and 90 on my garage. I did fog cylinders 2 weeks ago, but concerned about heat.

How can I check to see if I am getting fuel to car. 2000 gs 718

Will it be alright to connect a hose to my water hose, and put it inside the upper left input port, for I can run my engine for 2 minutes, do not have correct connection 2000 gs 718 see pic

Is there a lubricant location on jet pump drive for routine maintenance on a 2000 gs 717

Where is the water pump on a 2000 gs 718. I followed both 2 hoses from head, just went back out near jet drive. Someone maybe have a pic location

2000 gs 717 Where does my positive wire from starter connect to, does it have a stand alone solenoid see pic, if so where located,manual not clear, bought ski in pieces

Does anyone know about this selector knob under steering column, marking worn, it has 3 positions, and where does it need to be during running 2000 gs 718

Just rebuilt lower and upper end, on a 717 gs I have some concerns about the oil flow at first startup, do I need to prime oil pump line somehow, do not want to damage engine.If so can you send a pic, this is my first time with a 717, bought it and it was in complete piece, hope I have those 3...

I got this ski and a bucket of parts, need some help with drive shaft assembly parts, and what order, up to PTO. The black part ID, is much larger than that portion of shaft, unless something is missing or worn out allot. 2000 seadoo gs 717 short shaft

What's a good product to remove oxidation, and help restore paint on haul