Search results

1 means it is open, 0 is continuity. I've never done it, but looks like the F1 fuse. Can't be that hard. Plenty of YouTube videos.

Ohm the resistance when turning the float tube up and down. Manual should tell you the resistance.

Sorry...I really don't remember. Been a few months and 3 jetskis to repair later. I really don't think it is your gauge.

It ended up being the sending unit inside the tank. I bottom float stop had become unattached and fell into the bottom of the tank. I drained the fuel and fish it out with a coat hanger. I think I got a new float on Amazon. Assembled it back together and work get now. I'm selling the 1999...

The ECU is a replacement I bought for my 2007 RXT 215. Part# I have is for a 2008 RXT 215. Don't think that has any thing to do with it.

I did change out the coils and plugs before this test run. I'm suspecting the impeller and wear ring. From what I can see from the bottom, through the gate, the wear ring doesn't look that great and the impeller is a little dinged. No problem, I have changed them before. Usually, when I buy a...

Thinking awhile ago that my CandooPro was show a Rev limit of 7500 RPM. Don't know if the ECU can be flashed to 8000 Rpm? I'll have to revisit CandooPro.

I used an android apk called GPS Speedometer. My new Multigauge Cluster is actually 2-3 mph faster that the GPS app.

I have a 2007 Seadoo RXT 215 Supercharged. Took it out today. Topped out at 58mph @ 7400 RPM. Watched a video of the same jetski going 68mph @8000 RPM. What am I missing? Wear ring? Impeller? I'm just like Ricky Bobby, "I wanna go fast"!

2006 Seadoo GTI SE. The box in front of the ski. Under storage compartment is called what? The box mounted to the rear of engine is called what?

Will the 278002270 universal replacement work on my 2006 GTI SE? Currently has the bad 278002217.

My cluster is bad so I replaced with gauges. Fuel, RPM, and GPS for speed. When I bought this Seadoo last year, lowest price cluster was $750. Now they are $420 on ebay. $420 is expensive, but better than $720. My neighbor just bought a 2007 RXT with a bad cluster. I asked him just this...

Going to check oil pressure with a gauge tonight. May be going into limp mode from low oil pressure. No codes from my CandooPro software. I have replaced the oil pressure switch last fall. It wasn't it. The gauge cluster doesn't work. I replaced with gauges. Fuel, RPM, GPS, with individual...

2006 Seadoo GTI SE. Key to DESS post beeps twice. Start engine. Beeps continously for about 3-4 seconds and stops beeping. Is this normal? Engine idles perfect. Sounds like it goes into limp mode at higher RPM.

2006 Seadoo GTI SE. My Air Conditioning Gauge fittings will fit the fuel line tap. My fuel pressure tester threaded end connector measures about 7/16". Looks like a straight thread. The threads on my ac gauge measure, 1/2" straight. Do the make an adapter that will go from 7/16"straight...

With Pink and Pink/Blk jumped, my fuel gauge went to 1/4 tank. I lightly tap on the gauge and eventually the needle moved to fuel. Needle not working smoothly at all. Is this an indication of something unrepairable inside the gauge? The 4 leads at the back of the fuel gauge might have corrosion...

I think you are on to something. Trying to not to buy a gauge on ebay. Saw one for $125 with a broken plastic face. Measured my 5vdc source last night. I am getting 19.9 mV (.02 vdc). I'd guess that it needs at least .5-1 amp. Pretty confident that there is some high resistance in the Pink or...

With the fuel gauge unplugged and disconnected from the MPEM. If I use a 5vdc power source and connect the "+" wire the the Pink wire on the fuel gauge and the "-" wire the black wire (ground), shouldn't the fuel gauge read "F"? Wire schematic shows my ground to be pink/black but in reality it...

What's a good test for a fuel gauge out of the console?

I have fished out the float and end cap from my tank. I purchase a new float and have installed it in the baffle. Checked float to make sure it floats in gasoline. My 2 wires are Pink & Pink/Black. Testing with a multimeter, I get 2.2Ω with the float at the top position (FULL). With float at...