Search results

i took apart my mag cover and flywheel because the key broke. my question is i saw few threads saying about having the wrong flywheel and magneto how i check i have the right one on? the engine is 99 gsx 951

I’m looking on eBay for it

thanks for the replay. i order the sbt puller should arrive next week. for the pipe head i found the gasket its i took the exhaust pipe off the engine to get space to work in the hull and the pipe didn't had any gasket before. i will go get the fuel line tomorrow. and shop vac wont fit i need...

Did before when it was running had 125 I think if I remember on both and ski was running 58 mph

**update bendix is bad** So from what I understand I got 1999 seadoo gsx limited 951. Few days ago I died on water paddle back though battery was dead was right about that then I charge the battery but the ski was kicking the starter for few seconds and cut out only one time it start but I shut...

I had the engine running a bit rich so far so that good. I gonna take a video and upload it tomorrow to show what I’m stuck with now. I had some rope stuck to my shaft so I gonna take that apart to remove it. Ski won’t start out of no where. And sound weird. I did manage to get it running for a...

So I checked it it’s 99’ But on partzilla they have gsx limited 5848 and 5849 how I know which is what I got? And interesting part is the hull is black on bottom and red on top base on seadoo source it’s 1999 hull but my vin is 97 in the end and title says 97. I think the old owner had 99 and 97...

So the “genius” previous owner paint the engine all red but some area paint came off and it’s bare metal so I’m not sure. I know there is the 1997.5 engine and then the newer ones but even them when u go to partzilla they have on 1998 3 different engine same to 1999.

i got what i though 1998 seadoo gsx limited 1998 but it was painted cheap. after power wash the ski i saw some color come off. now on title says 1997 gsx but the real color of the haul is black on bottom and top is red like the 1999 model base on the seadoo source website. the engine look like...

will check that. but main question is stays remain do i setup first rpm or throttle cable?

He claimed to use all oem mikuni parts. Accelerator pumps does squirt. I have slack on the throttle thumb. My gauge isn’t working to I replaced it with marine gauge from Amazon and it’s reading the rpm when I went to try to adjust the idle I notice the rpm won’t raise up sound like it when up a...

so i got 1998 seadoo gsx limited 951 carb oil pump deleted its a premix i got the air silencer from ebay assemble it adjusted everything to manual setting on carb, carb was rebuild base on previous owner. the issue i got is the ski dies on acceleration but if i rev it few pumps it goes fine if i...

so i got it fix! following my line into the carb about 11-13 inch before the end of the cable there is the tps sensor that split the cable from throttle to oil and throttle. i open the tps plastic open and the inside is dry clean all put some white grease for the plastic leveler inside, then i...

hi everyone i hope i post it in the right place. i have 1998 gsx 951 limited used ski i got on trade, yesterday i notice the throttle cable is sticking and brake apart. this cable have the sensor in mid cable. my question can i replace this with regular throttle cable or i have to use the same...