Search results

Thanks so much so frustrated

It’s cold when I clear it. I started it and light pops on. Staying in limp. Yes flow. Water and coolant flowing hoses correct. Exhaust cold when running. Has to be wire or something I’m missing. Not that good on checking resistance or where to start. I changed exhaust sensor just in case. Not...

So back at it all hose’s correct and thermostat. P197 code engine light on and limp. Disconnect battery cleared codes on Candoo. Start back up. No code on Candoo however limp light and same code.???? Any thoughts. Can I get it out of limp mode.

Hi need a new or used hull. Thanks

Exhaust is cold. Engine hot then alarm beeps. Thanks

I don’t explain well but think you get most of it

Engine temperature. Hoses are correct. I pulled this lemon engine 5 times. Replaced everything I can think of. Dealer couldn’t figure it out. So I can only think thermostat. Tomorrow I’ll pull it out and let it run. Just strange I checked thermostat. Engine only has 3 hours on it. Blew #2...

Sorry no all clear. Can I remove the thermostat and not use one? Dealer was going to pull and put oil pumps so I did that. Screens were clean

Hi so new sensors, new oil pumps both, pulled thermostat and opening with hot water on it. Started 5 times with water. Exhaust seems cool. Still in limp with P0197 code?? Frustrated to say the least.

Which pump? I think I’ve tried everything. It shouldn’t overheat using hose water correct?

Pulled engine 2 new oil pumps screen etc. Cooling plate fine, thermostat fine, exhaust cool to touch running out of water. Raw water fine. 5 minutes in overheats. Canddoo has fault codes for intake sensor a different conversation