Search results

2,500 - 5,800

Message critracer and see if he can help you out, he is the one that made the mount plates for me.

Airplanes are my first passion, skis second. Got my private in this, wasn’t cheap at 9gph lol

Is that an aerobat i see in the background? [emoji102]

I think I have a few of those rubber gauge supports 293-720-005 if you still need one

Thanks! I needed to get this thing done so I can put my car back in there lol

I’m doing a 717 to 951 swap, definitely not cheap and definitely not easy, check out my thread on it. Hx 951 Winter Project

Very close to being done! Got the exhaust and brackets all tightened up on the work bench Relocated the fuel strainer. Dropped the motor in for hopefully the last time, hooked all the electronics up for the first start. It started right up, so I weeded the wiring harness to get...

Little update here, got the carb rebuild kits in so the carbs are bolted onto the motor hopefully permanently. The exhaust pipe hitting the hull problem has been solved but may hinder performance a bit, but we will see I really didn’t want to but I did have to cut into the hull a little...

Finally got the cylinders back from the machine shop, and was able to finish assembling the engine I had to get a new stator and flywheel because old one was rusty and didn’t pass ohm test. Had to rebuild the starter aswell. Just put the motor back in the ski today after buying the...

Had an hx with factory pipe and other ad-ons. It ripped pretty good until it didn’t. Blew out rod bearing on pto side. I was just going to do a full rebuild on the 720, then I got to thinking and the factory pipe just introduces so much hassle and reliability issues. The fpp setup required...

No problem! Glad to help!

Pm sent!

still have a front plate?

Yeah, I ran a flow restricter to where the ecwi solenoid would be, before installing the solenoid. Then kept Allen screw. the second fitting on the other side of the manifold is the water drain that goes to the pisser. Being completely honest with ya, there’s really no point to having the...

It’s a 3/8 inch spray bar fitting FACTORY-PIPE. Spray Remote ECWI 1/8 X 1/4 - Matos import

If you have the micro touch and ecwi solenoid then no, but I didn’t have any of that stuff so I had to use a flow restricter.

Yeah the adjustment screw is that Allen bolt fpp recommends 3/8 turns out from bottom but to start off I went with 3/4 to 7/8 out

This is what I have