Search results

2003 seadoo speedster. Mercury m2 240. Took out of storage from winter, changed battery and no beep when turning ignition. A few times it beeped on its own when I walked away and heard it beep. Tried touching all wires etc. checked all fuses. New battery etc. I have the key left in the on...

Understood. Thank you. And is the nut normal thread direction or opposite? Righty tighty, lefty loosey???

Ahhhhh. Gotcha. Good thinking. Thank you

Thank you. Last question regarding tools to remove impeller? What’s so “special” about the socket to remove the impeller that costs $138.00???

Hello, I have a 2003 seadoo speedster mercury 240 v6 EFI. I’m looking to purchase an impeller and can’t seem to find information on what size etc and where to buy. Any information will help. Thank you

Thank you!

Hello, I have a 2003 seadoo speedster with a mercury 240 efi, is the wear ring replaceable? Meaning, is there a plastic sleeve in it. When I look at it, it seems to be just plain corroded aluminum. Do I have to buy the whole housing?

Hey guys, I have a 2003 seadoo speedster with an M2 v6 efi, when taking fuel pressure reading on test port, is that reading before the fuel regulator or after the regulator? While boat is running I have about 35 PSI. Manual says 41-45 psi to the injectors and that the electric pump is capable of...

I have a 2003 speedster mercury v6, 240hp EFI that’s not holding fuel pressure. When I turn key to “on” position, I get 41 PSI, then drops right to 10 instantly. Boat runs great on land, dies when in water when I give it gas. Compression is 135 across all 6 cylinders. PLEASE HELP!!!

Yes very simple. Just two philips head screws hold it in place. Remove screws and hose and pull it right out. If you install a new one, be sure to put a little lube on o-rings.

Heres a link for a little less $$$. Walmart

Well, I bought my speedster knowing it doesn’t run, long story short, the regulator was installed crooked and stem was bent, thus not being able to open. Quantum fuel systems list one for $50, says it replaces OEM #883257t1, which is what I need. When I received it, it was totally wrong. They...

Where can I buy a Fuel pressure Regulator for a 2003 speedster m2 v6 240hp??

Like I mentioned, purrs like a kitten on land, I can whack the throttle and comes back to idle pretty smoothly.

Running voltage is 12.3VDC

Well I got new regulator and installed. Took all pumps apart and cleaned. Fires right up on land with hose. Started about 10 times (once a day for about 3 minutes). Put in water, idled great in forward for about ten minutes then dies, starts back up, runs about 5 seconds and dies again. Put back...

So I took out fuel regulator, nozzle tip that seats inside VST was bent. Used a nail to try press on spring inside regulator. Wouldn’t move. Stuck closed. With a LOT of force I managed to push it and it stuck open now. Buying new one obviously. The main power relay is located right next to...

Just checked all grounds. All good. Checked pressure just checked all grounds. All are good. Checked pressure at tire valve on top and only have 12psi. When cranking goes down to almost zero. Suggestions?

Hey, thanks for responding. I’ve checked every wire harness, took apart, cleaned throughly with contact cleaner and reapplied die-electric grease to all plugs. As far as e-stop, it’s a universal one, 1 NC contact and 1 NO contact. If I hook up it wrong, I don’t get a beep tone when I turn key...

2003 seadoo speedster m2 v6 240 Hello, I just bought this boat from member “tkalb22”. This boat won’t start unless I spray “starting fluid” , which I know not to do!!!! Just did it twice to see if it turns over and it does then dies out. This is where I’m at..... I turn key, get one beep, fuel...